Arctic
Remote Controlled
Tower Fan
Instruction Booklet
KFA835
Contents
Kambrook Recommends
Safety First
p4
p6
p7
Your Kambrook Arctic
Remote Controlled Tower Fan
Using Your Kambrook
Arctic Remote Controlled Tower Fan
Care and Maintenance
Warranty
p10
p12
Kambrook Recommends Safety First
IMPORTANT: Please retain your
instruction book for future use.
At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.
Important Safeguards For Your Kambrook
Arctic Remote Controlled Tower Fan
• Carefully read all instructions before
operating the Kambrook Arctic Remote
Controlled Tower Fan for the first time
and save for future reference.
• To protect against electric shock, do no
immerse the fan, cord or plug in water
or any other liquid
• Never carry the fan by the cord or yank
to disconnect from an outlet; instead,
grasp the cord and pull to disconnect.
Do not pull the cord around sharp
edges or corners.
• This fan is intended for household
use only and not for commercial or
industrial use.
• Disconnect the power plug
before dismantling, assembling
or before cleaning.
• Avoid touching mobile parts of the fan.
• Ensure the fan is on a dry and
even surface.
• Never insert fingers, pencils or any other
objects through the guards whenever
the power plug is connected, in
particular while the fan is switched on.
• The fan must not be used if the guards
are not fastened correctly, according
to these instructions.
• Do not operate in the presence of
explosives and/or flammable fumes
or liquids.
• Do not unplug the fan by pulling on
the cord.
4
Important Safeguards For All
Electrical Appliances
• Fully unwind the power cord before use.
• Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.
• Do not let the power cord hang over
the edge of a bench or table, touch
hot surfaces or become knotted.
• To protect against electric shock do not
immerse the power cord, power plug or
housing in water or any other liquid.
• The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
• This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors. Misuse may cause injury.
• The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It
is advisable that a safety switch with
a rated residual operating current
not exceeding 30mA be installed in
the electrical circuit supplying the
appliance. See your electrician for
professional advice.
• Children should be supervised
to ensure that they do not play with
the appliance.
• It is recommended to regularly inspect
the appliance. To avoid a hazard do
not use the appliance if power cord,
power plug or appliance becomes
damaged in any way. Return the
entire appliance to the nearest
authorised Kambrook Service Centre
for examination and/or repair.
5
Your Kambrook Arctic Remote
Controlled Tower Fan
1. Tower fan body
Parts List
2. Choice of 3 speed settings,
•
•
•
Tower body
2 piece base
Remote control
nature and reduction mode
3. 60° oscillation to disperse the air
throughout the room
Not Shown
Fastening screws attached in the
base of the tower
4. Eight hour auto-off timer
•
5. Convenient carry handle for
easy portability
6. LCD screen
7. Small footprint
8. Remote control
6
Using Your Kambrook Arctic Remote
Controlled Tower Fan
3. Pull and place the power cord
Before First Use
Remove any promotional material
from the fan.
across the already positioned
half base (a), positioning it into
the cord track. Then align the
other half base (b) over the
support posts, and slightly over the
already positioned half base (a).
Firmly push down on the half base
(b) until the bases are locked in
place and flush. (Fig. 2)
IMPORTANT: When
unpacking the fan, check
to see you have received
all the items listed in the
Parts List, before discarding
the packaging.
Assembling Your Arctic
Remote Controlled
Tower Fan
Base Assembly
1. Turn the Tower body upside down,
and remove the fastening screws
from the bottom of the tower.
2. Thread the power cord through
the half base (a) square opening.
Position the half base (a) onto
the support posts, located on the
bottom of the tower body.
Fig. 2
4. Secure the joint base to the Tower
Body with the fastening screws.
5. Check the power cord is still
located in the cord track.
6. Turn the tower over to the upright
position, it is now ready for use.
(b)
(a)
Fig. 1
7
Using Your Kambrook Arctic Remote Controlled
Tower Fan
continued
To Operate the Arctic
Remote Controlled
Tower Fan
Plug the cord into a 230V or 240V
power point and switch on.
Setting the Oscillation
The oscillation function works in all air
flow settings.
Press down the Swing button to
activate. The fan will begin to
oscillate from side to side.
Press the Swing button again to stop
the fan from oscillating.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit as your fan, when it
is in use.
Setting the Timer
The Arctic Tower Fan incorporates an
eight hour, count down timer, which
allows you to set the fan to turn off
after 1, 2, 4 or 8 hours.
Press the Timer button once to
To turn the fan on simply press the
POWER button.
activate the timer setting. The timer
will then be set to turn off in 1 hour
and 1h will appear on the LCD screen.
The Arctic Tower Fan has three fan
speed settings; (LOW),
(HIGH).
(MED) and
Press the Timer button again, to have
the fan switch off after 2 hours, and
2h will appear on the LCD screen.
Similarly, pressing the Timer button
a 3rd or 4th time will set the fan to
switch off after 4 or 8 hours, and the
relevant setting will appear on the
LCD screen.
Press the Fan Speed button once for
LOW speed, a second time for MED
and a third time for HIGH. The fan
speed selected will be displayed on
the LCD screen.
To turn the fan off, simply press the
POWER button.
1 hour
2hours
STOP
4hours
8hours
Your Arctic Tower Fan also features a
NATURE and REDUCTION setting.
Using the Nature and
Reduction Settings
Both the NATURE and REDUCTION
settings can be used on any fan
speed. The LCD screen will indicate
what mode the fan has been set in.
The NATURE mode simulates the
natural rise and fall of the wind
over time.
Fig. 3
8
Once a fan speed setting is selected,
press the MODE button once to
activate the NATURE setting. The
fan will now alternate between the
pre-selected setting, all lower settings
and OFF.
MED, after 30 mins it will drop down
to LOW, and remain on LOW until the
unit is turned off.
To switch the REDUCTION mode off,
press the MODE button once. The fan
will now be in normal operation.
To switch the NATURE mode off, press
the MODE button twice, until the
indicator light disappears.
The REDUCTION mode allows you to
decrease the fan speed over time.
Using the Remote Control
The remote control buttons operate
in the same way as those on the fan
control panel.
Once a fan speed setting is selected,
press the MODE button twice to
activate the REDUCTION setting. After
30 minutes, the selected setting will
drop to the next lowest setting. For
example if the fan speed is set at
Your remote control takes 2xAAA
batteries, and can be conveniently
stored in the compartment on the
rear housing of the unit.
NATURE:
REDUCTION:
Random speed cycles (90-second cycles)
Speed cycles (90-second cycles) Speed steps down
every 30 minutes for MED and HIGH settings.
Pre-select speed
/
/
/
(LOW)
(MED)
(HIGH)
Pre-select speed
/
(LOW)
speed
variation speed
Pre-select speed
/
(MED)
Pre-select speed
speed
variation
speed
variation
speed
Pre-select speed
/
(HIGH)
Pre-select speed
speed
variation
speed
variation
speed
variation speed
9
Care and Maintenance
Always switch the Arctic Remote
Controlled Tower Fan off, prior to
cleaning the housing.
To clean the outside of the fan, wipe
the exterior with a soft, damp cloth.
Never use an abrasive cleaner.
When not in use, store the fan
(preferably in its original box) in a
cool, clean and dry location.
10
Notes
11
Kambrook 12 Month Replacement Warranty
In Australia, this Kambrook Replacement
Warranty does not affect the mandatory
The Kambrook Replacement Warranty does not
apply to any defect, deterioration, loss, injury or
statutory rights implied under the Trade Practices damage occasioned by, or as a result of, misuse
Act 1974 and other similar State and Territory
legislation relating to the appliance. It applies
in addition to the conditions and warranties
implied by that legislation.
or abuse, negligent handling or if the product
has been used other than in accordance with
the instructions. The Kambrook Replacement
Warranty excludes breakables such as glass and
ceramic items, consumable items and normal
wear and tear.
In New Zealand, this Kambrook Replacement
Warranty does not affect your mandatory
statutory rights implied under the Consumer
This Kambrook Replacement Warranty is void if
Guarantees Act 1993 in relation to the appliance. there is evidence of the product being tampered
It applies in addition to the conditions and
guarantees implied by that legislation.
with by unauthorised persons.
If the product includes one or a number of
This Kambrook Replacement Warranty is valid only accessories only the defective accessory or
in the country of purchase, but other statutory
warranties may still apply.
product will be replaced. Subject to your statutory
rights, in the event of Kambrook choosing
to replace the appliance, the Kambrook
Replacement Warranty will expire at the original
date, i.e. 12 months from the original date of
purchase.
This Warranty card and the purchase receipt
for this product are to be retained as proof of
purchase and must be presented if making
a claim under the Kambrook Replacement
Warranty. Please note that under any applicable
statutory warranty you are not required to
produce these documents, but may be required
to provide a proof of purchase.
In the event that you need some assistance
with your Kambrook appliance, please contact
our Customer Service Department on 1300 139
798 (Australia) or 09 271 3980 (New Zealand).
Alternatively, visit us on the website at
Kambrook warrants the purchaser against defects
in workmanship and material for a period of 12
months domestic use from the date of purchase
(or 3 months commercial use).
Kambrook 12 Month Replacement Warranty
Your Purchase Record (Please Complete)
Attach a copy of the purchase receipt here.
Date Of Purchase ________________________________
Model Number ___________________________________
Serial Number ____________________________________
Purchased From __________________________________
(Please don’t return purchase record
until you are making a claim)
Kambrook - New Zealand
Private Bag 94411
Botany, Manukau
Auckland 2141
New Zealand
Customer Service Line/Spare Parts
0800 273 845 or 09 271 3980
Kambrook - Australia
Building 2, Port Air Industrial Estate
1A Hale Street
Botany NSW 2019
Australia
Customer Service Line 1300 139 798
Customer Service Fax 1800 621 337
Customer Service Fax 0800 288 513
Due to continual improvement in design or otherwise, the product you
purchase may differ slightly from the illustration in this book. Issue A10
|