SB-SC-TC/10W3v3_INSTTR_SKU##01124
INSTALLATION
D I F F I C U LT Y :
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
OUT
OF
I N S T A L L A T I O N G U I D E
for the
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
S B -S C -T C /1 0 W 3 v 3
25
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
2005 - Up Scion tC
S T E P
1
Place the rears seats in the upright position.
Remove the factory cargo cover, carpeted flooring, jack tools
and the spare tire.
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
S T E P
2
Remove the black foam blocks and the large round rubber
grommet from the spare tire wheel.
Grommet
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 1 year if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
S T E P
3
Place the Stealthbox® into the spare tire wheel. The flat end
of the Stealthbox® is to face the back of the vehicle.
Continued on Next Page
SB-SC-TC/10W3v3_INSTTR_SKU##01124
S T E P 1 2
I N C L U D E D H A R D W A R E
Apply a bead of silicon or any adhesive sealant around the
hole of the supplied aluminum plate.
(4) 3/8-inch USS Fllaatt WWaasshheerr
(1) 4-iinchh xx 66--iinncchh xx 33//1166--iinncchh AAlluummiinnuumm PPllaattee
(2) 3/8-iinchh Spllit Lockk Washerr
(4) 3/8-innch x 1-1//44--inch Feennder Washher
(2) 3/8-inchh x 1-3/4-incchh -16 Hex CCap Screws
(2) 3/8-inchh --16 Hex Nut
(2) Foamm Flooriing Sppaacceerrss
(1) Carpetedd FFllooorring
S P E C I F I C A T I O N S
Enclosure Type: Acoustic SSuussppeennssiioonn ((sseeaalleedd))
Driver Type: 10W3v3-4
Nominal Impedance: 4 ohms mono
Continuous Power Handling: 3000 Watts
S T E P 1 3
P O W E R R E C O M M E N D A T I O N
From under the vehicle, place the supplied aluminum
plate(front bolt assembly only), fender washers, flat washers,
lock washers and then hex nuts onto each protruding hex
cap screws and secure.
BRACKET FROM STEALTHBOX
VEHICLE'S FLOOR
HEX HEAD BOLT
FLAT WASHER
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1 when
being used to power your Stealthbox®.
Note: For added protection, it is recommended that
you apply a bead of silicone between the vehicle and
the fender washer. After the bolt assembly is tightly
secured, it is also recommended that vehicle under-
coating material is applied to the exposed assembly.
ALUMINUM PLATE(front bolt assmebly only)
Amp LP Filter
Mode/ Slope
+1 2 VDC
Ground Remote
Preamp Output Section
Output Mode
Bass Control
Infrasonic Filter
Amplifier Input Section
Input Voltage Input Sens. Signal Sensing
FENDER WASHER
LOCK WASHER
FLAT WASHER
HEX NUT
Full-Range/ Low-Pass/ High-Pass
Off/ 3 0 Hz
+7
Off/ 1 2 dB/ 2 4 dB
Low/ High
Off/ On
+3
+1
+1 0
+1 3
J L A U D IO
2
5
0
/1
a lif ie
m
o
n
o
b
lo
c
k
s
u
b
w
o
o
f e
r
m
p
r
Left Ch.
Right Ch.
LF Boost (dB) Filter Freq. (Hz)
Left Ch.
Right Ch.
S T E P 1 4
Place both supplied foam supports around the spare tire as
shown to the left.
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
Place the spare tire with the yellow side up onto the
Stealthbox® and secure with the factory hold down bolt that
was removed in STEP 1.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Place the supplied replacement flooring into vehicle.
Note: If the child LATCH system will be used, slight
modification of the supplied flooring is required.
Front Speaker Size / Location: 6.55-inncchh SSeeppaarraatteess // FFrroonntt Doorss
Fits JL Audio Models: TR650-CSii,, TTRR665500--CCXXii,, VVRR665500--CCSSii,, VVRR665500--CCXXii,, XXRR665500--CCSSii,, XXRR665500--CCXXii && ZZRR665500--CCSSii
Rear Speaker Size / Location: 5..225-inch / Rear Deckk
Fits JL Audio Models: TR525--CXi, VVRR552255--CCXXii && XXRR552255--CCXXii
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
w
w
w
. j l a u d i o . c o m
(9 5 4 ) 4 4 3 -1 1 0 0
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011224-11-28-2006
•
Printed in USA
•
©2005 JL Audio, Inc.
•
U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
Page 3 • JL Audio, Inc 2006
|